Drop In Replacement Gear Reducers

Drop In Replacement Gear Reducers
Steel Mill Galvanizing Line

These various sized units were ordered to replace the existing boxs which were no longer available. The original manufacturer had introduced a new line with a new bolt pattern rendering the old model obselete. The prime objective was for a ratio change to speed up the galvanizing line. Delta came on site and measured up all the boxs so that the new ones could be made to suit the existing mounting configuration.


Drop In Replacement Gear Reducers
Cooling Tower Drive

Ordered to fit where a replacement couldn't be found.


Drop In Replacement Gear Reducers
Inline Reducer

This reducer was available from the supplied with a cast iron housing only. The steel mill where it was used found that even a small bump with a several ton roll of steel would break the box. The machinery was built around the reducer which prevented any other reducers from being used as is. Delta's solution was to build a new fabricated steel housing while utilising the old gearing. Further units were supplied completely new as the mill replaced all the cast iron units. Reducers that were averaging 4.5 months over 2 years have now been running in excess of 2 years.


Drop In Replacement Gear Reducers
Plumbed for Lubrication

External electric lubrication installed for lubrication to all bearing as well in into mesh.


Drop In Replacement Gear Reducers
SR-18

An older model reducer that was very common in Pulp & Paper Mills is replaced By a new Delta box with gearing made to current AGMA standards. The service factor is increased by more than double of what was. Maintenance, noise and cost were all reduced.